Product Description Hunter Wireless Rain Clik Sensor Rain-Cliks Quick Response Stops Irrigation The Instant Rain Starts to Fall Most rain-sensing devices work by accumulating a set amount of rainfall before a switch is activated that interrupts the circuit from the controller and shuts off the system. In that accumulation time, the system will unnecessarily continue to water. This can look especially bad for conservation-conscious municipalities, businesses, and residences. With built-in Quick Response technology, the Hunter Rain-Clik and Wireless Rain-Clik can command a controller to shut off right when it starts to rain. The Rain-Clik can be mounted on an eave or any flat vertical surface like a wall or fence. A gutter mount is also available that allows for easy installation of the Rain-Clik on the edge of a gutter. Specifications Wiring: normally closed or normally open Time to turn off irrigation system: 2 to 5 minutes approx. for Quick Response Time to reset Quick Response: 4 hours approx. under dry, sunny conditions Time to reset when fully wet: 3 days approx. under dry, sunny conditions UL listed, CUL (CSA), CE Switch rating: 24 VAC, 3 A Freeze sensor shuts system off when temperatures fall below 37 F (Rain/Freeze-Clik model) System operating frequency: 433 MHz UL listed, FCC approved, suitable for use in Australia, CUL (CSA), CE Communication range up to 800 ft. line of sight (Wireless model) Receiver input power: 24 VAC (from controller) 70cm Cable length from Module Click for Product Brochure Click for Product Installation Guide